 |
10. Mounting Through-hole Type Devices
|
|
1.
|
Stanley does not guarantee direct mounting of the through-hole type devices to the boards.
Directly mounting the through-hole type devices (excluding direct mount type) could lead to damaging the LED epoxy from board warp, lead cutting and clinching during the soldering process.
(If direct mounting must be performed, please take all necessary precautions to make sure there are no problems)
|
|
2.
|
To determine the mount positions of all through-hole type devices other than the direct mount type, please use a spacer or LEDs equipped with stopper.Please mount so that the stopper should not dig into the hole of the substrate, when type with stopper is used.
|
|
3.
|
To determine mount positions of LEDs using a casing, please take into account the dimensions of the casing, board, device to avoid excessive stress on the lead.
Please fix the LED within the casing using the lead, and do not use adhesives, resin, or any other materials to fix the LED position.
|
|
4.
|
With regard to using an inserter (automation), please adjust the insertion pressure to the lowest possible setting, and minimize the clinch angle as far as it can hold the component.
Stanley recommends the pusher of 0.2MPa or less, the clinch angle of 45 degree, or more for Anode (Emitter) and the clinch angle of 15 degree, or more for Cathode (Collector) .
(The polarity will be reversed on EW, BR, KR, DNF, DNP, DN, NR and FH products.)
|
|
|
|
|
